Hf-scientific MicroTUV Online UV %Transmission Analyzer User Manual

HF scientific, inc.3170 Metro ParkwayFort Myers, FL 33916Phone: (239) 337-2116Fax: (239) 332-7643 Catalog #22814 (1/03) MicroTUV ONLINE UVTRANSM

TUV (1/03)REV. 0.22.4.4 Analyzer Recorder - VoltageRecorder output voltage is selected at the terminal block labeled ANALOG VOLTAGE (J6). Only one of

TUV (1/03)REV. 0.23.1 START UPNOTE: It will be necessary to verify each of the user settings, in the Analyzer, and/or change some,when starting the u

TUV (1/03)REV. 0.24.2 CALIBRATION ALARMS Cont'dB: The Analyzer and Sensor/Sampler will continue to operate and ignore the attempted calibration.T

TUV (1/03)REV. 0.2GUIDE TO FUNDAMENTAL TROUBLESHOOTING6.0 TROUBLESHOOTING6.1 GENERAL NOTESService and Technical Support are available from HF scientif

TUV (1/03)REV. 0.26.3 ANALYZER ERROR CODESThe following are the error codes that may be indicated on the analyzer. The Analyzer switching to theError

TUV (1/03)REV. 0.26.4 REPLACEMENT PARTSCatalog No. Description20955 Fuse, 1/2 amp Fast Acting 5 x 20 mm (240V)20815 Wire Shielded RS-485 (per foot)209

TUV (1/03)REV. 0.2Figure 3Analyzer Outline DimensionsXX.XX=INCHES(XX)=mmPage 10

TUV (1/03)REV. 0.2Page 11Analyzer(Rear inside view)Figure 4Alarm and Interconnect Cable Connections TUVANALYZER PC BOARD

TUV (1/03)REV. 0.2Figure 5Analyzer Menu Flow ChartPage 12

TUV (1/03)REV. 0.2WARRANTY HF scientific, inc., as manufacturer, warrants to the original purchaser of the instruments to befree of defects in mat

TUV (1/03)REV. 0.2

TUV (1/03)REV. 0.25.0 FLOW SWITCH ... 66.0 TROUBLESHOOTING ...

TUV (1/03)REV. 0.2

TUV (1/03)REV. 0.2DECLARATION OF CONFORMITYApplication of Council Directive: 89/336/EECStandards to which Conformity is Declared:Product Safety Immun

TUV (1/03)REV. 0.2

TUV (1/03)REV. 0.21.0 IMPORTANT INFORMATION1.1 HOW TO USE THIS MANUALThis equipment, while sophisticated, has been designed for simple and easy op

TUV (1/03)REV. 0.22.0 INSTALLATION2.1 PACKING LISTCONTENTS QUANTITY Mounting Bracket - installed 1 RS-485 Interface - installed 1 O & M Manual

TUV (1/03)REV. 0.2To remove the access cover:Step 1) Loosen the two Analyzer clamping knobs.Step 2) Swivel the Analyzer top forward, such that the